Dog Bone Material Testing

S plastics is subjected to an axial load.

Dog bone material testing. If a material is thicker than 14mm then it must be reduced. The high fiber direction strength and orthotropic material behavior of composites often preclude the use of specimen designs and methods of load introduction developed for use in testing metals and plastics. Flat dog bone specimens can also be die cut from a plastic sheet or machined from a block. Dog bone shaped dts test specimens used for different brittle materials such as concretes cements and ceramics were investigated to be also used in rock material testing in this study.

If all of the sample materials had the same shape it s easier for us to compare the properties of the different materials. To eliminate the holding and gluing problems making the direct tensile strength test hard to be applied a new method of testing specimens prepared using lathe machine to make the dog bone shape is assessed whether it could be applied to determine. Properties that are directly measured via a tensile test are ultimate tensile strength breaking strength maximum elongation and reduction in area. Report all factors that influence the tensile properties such as.

A tensile test is a standardized test used for finding the properties for a specific material. The plastic dog bones are typically molded in a die to produce test specimens depending on the specific requirements of the applicable tensile testing standards. The cutting method is used to create samples from flexible material as it is easier to push the cutter through them without cracking the sample due to their ductile nature. Tensile testing also known as tension testing is a fundamental materials science and engineering test in which a sample is subjected to a controlled tension until failure.

This test is a destructive method in which a specimen of a standard shape and dimensions prepared according to astm d 638tandard test method for tensile properties of. 4 2 this test method is designed to produce tensile property data for quality control and research and development. From these measurements the following properties can also be determined. The test method can be used for testing materials up to 14mm 0 55 in and the material should be in the shape of a dumbbell or dog bone.

Consider for example the flat dog bone shaped specimen that s commonly used for tension testing fig. In a tensile test the sample material is lathed into the shape of a dog bone for comparing the results of other materials. A dog bone or dumbbell specimen is used to tensile test plastic materials per astm d638.